Before Sealcoating: Who Protects the Sidewalks, Walls, and Parked Cars?

Published 2026-11-16 · By Reagan Carrier · 456 words

Before sealcoating, walk the pavement boundary with the contractor and identify everything that must stay uncoated. Agree on who moves vehicles and portable items, how adjoining surfaces will be protected, and who handles an accidental splash. Include these arrangements in the work plan rather than leaving them for the spray crew to discover.

Mark the boundary, not just the square footage

A useful protection list names locations: the concrete walk at the front entrance, brick beside the drive-through, painted posts, garage doors, and vehicles along the neighboring edge. Take dated photographs of existing marks and give the contractor a marked-up site photo. Distinguish surfaces included in the coating scope from surfaces that are simply nearby.

For a shared commercial property, ask each tenant who can authorize vehicle moves. Set a confirmation time before mobilization and name someone who can resolve an unmoved car. At a home, include trailers, basketball equipment, and planters in the conversation. Do not assume the pavement contractor has permission to relocate them.

Ask how the edges will be handled

The Pavement Coatings Technology Council's best-practices guide calls for protecting adjoining surfaces during edging and advises against spray application in windy conditions. It also identifies brush, squeegee, and spray application methods. Ask the contractor to explain the method and protection planned for your particular boundary; a large open parking area and a narrow strip beside a wall need separate attention.

Use three questions at the walkthrough: Which surfaces need protection? Who installs and removes it? What happens if conditions change before that edge is finished? Record the answers alongside the work limits. This is a coordination checklist, not a direction to use one application method everywhere.

Agree on a reporting and cleanup contact

The Council notes that accidental sealer deposits are easier to remove before drying and recommends testing removal methods on a small area to check their effect on the surface. If you notice a splash, notify the contractor promptly and photograph its location. Ask for a surface-appropriate response instead of starting an improvised chemical cleanup.

Before closing out the work, revisit the protection list together and document any unresolved marks and the agreed next step. Milliken Corporation offers sealcoating and striping services in Middle Tennessee. When discussing a property in Gallatin or Nashville, include photographs of close boundaries with the proposal request so protection is part of the initial conversation.

Frequently asked questions

Does requesting edge protection mean the entire lot must be brushed?

No. Ask the contractor to explain how the selected application methods and protection arrangements fit each part of the site.

Should nearby vehicles be included even outside the work boundary?

Yes. Identify them during planning and coordinate with their owners. Let the contractor establish the clearance needed before application begins.

Sources and further reading